4.4.8 Load Default
This function is to reset the configuration of switch to the factory default. Click on the
System/Load Default
menu
button, and the following table shows in the web main page.
CAUTION:
This operation will result in all the parameters losing.
4.4.9 Reboot
This function is to reboot the system.
4.5 Port Management
4.5.1 Port Configuration
This function is to configure and to view the configured port management status, port negotiation mode and the
port flow control function.
。
Management Status:
Display port status: Enable or Disable. Disable is to turn off the port.
。
Link Status: “Up”
to indicate the port is linked while
“Down”
to indicate the port is not connectd.
。
Speed:
Shows the negotiation mode and the running speed on the port.
。
Duplex:
Displays full-duplex or half-duplex mode.
。
Flow Control:
Display Flow status of port: Enable or Disable, Disable indicates Flow control is off.
。
Auto:
Display which mode the port is auto-negotiated
。
Config:
(configured) Displays the state defined by the user.
。
Atual:
Displays the negotiation result.
