Planet WAP-200N, User Manual, Page: 59 / 118

User Manual of WAP-200N/WBS-200N
-58-
Forwarding state is entered. This delay is provided so that when a new
bridge comes onto a busy network, it looks at some traffic before
participating.
•
Priority
Specify the Priority number. Smaller numbers have greater priority.
•
Accept
Click Accept to apply the setting.
•
Cancel
Click Cancel to cancel the setting.
5.4 Router (WISP Mode Only)
5.4.1 DHCP Server Settings
Go to the “ Operation Mode ” page to configure the device as “ Client Router ” and then go to “ Router

LAN
Settings ” to configure the device’s LAN IP settings in client router mode.
On this page, enable the DHCP server to assign IP address to local wired/wireless clients after the device is
connected to the remote AP supplied by wireless ISP.
Figure 5-22 DHCP Server Settings
The page includes the following settings:
Object Description
•
IP Address The LAN IP of the AP.
•
IP Subnet Mask
The LAN subnet mask of the AP.
•
Use Router As DHCP
Server
Select it to enable DHCP server. In here the device is acting as a router.
•
Starting IP Address
Specify the starting IP address for the DHCP range.