7.
Connect the Ethernet and/or modem, ISDN, depending how you want to
access IKVM-8000.
The rear side of IKVM-8000 provides a RJ-45 connector for Ethernet. The
connector is used either for a 100Mbps 100BASE-TX connection or for a
10Mbps 10BASE-T connection. The adapter can sense the connection speed
and will adjust to the appropriate operation mode automatically.
2.5 Use IKVM-8000 as a normal KVM switch
The power on state of IKVM-8000:
When you power on KVM switch, it will ask for the password,
the default
password value is eight zero –“ 00000000 “
. Please key in eight zero and
enter the same value at retype field.
Note:
Before you get acquaintance with the operation of OSD manual, please
don’t change the password – i.e. keep default eight zero (00000000) value.
The Membrane Buttons:
~
Pressing the individual button to get PC port you want.
PC port LED Indication :
There are two LEDs--- Power LED
(The LED is marked by “ “)
and
Link LED
(The LED is marked by “ “ )
accompanied with each PC port.
If the selected PC is shut down or this PC port is disconnected to the PC,
the corresponding power LED is off (But, if this PC is PC99 type, the se-
lected power port LED is lit) and the Link LED is flash. If the selected PC
is powered on and well connected, the corresponding Link LED and
power LED is lit.
6