-
44
-
4.4.2.3
Export Event Video
To export event video, follow these steps:
•
Press SEARCH and play wanted event video. To play event video, refer to OSD Setup
Manual Section Search Recorded Video.
•
After entering the playback mode, press COPY. The “ezBurn” window will display as below
figure. The information shown on it is read only.
•
Press ENTER to start the export the whole event video to the connected device; or, press
ESC to abort.
ezBurn confirmation
Selected Device: Built-in DVD+RW
All data on the disc will be erased.
Exported Required Size = 11 MB
Export Event Info:
Data
Time
Ch
Type
2008/05/07 AM10:42:35
13
Motion
Enter: Yes ESC: No
•
If there is no exportable device connected to the DVR, then a warning message will be
shown on the screen.
4.5 Dome Control
The DVR allows user to control a dome camera by the front panel. In Live mode, user can press
CHANNEL key to display the desired dome camera in full screen. To enter dome control mode, press
the DOME key and press channel key 2 to display the hint screen. To exit the dome control mode and
return to live mode, press ESC or DOME.
In dome control mode, press CALL + ENTER to open the OSD setup menu of the dome camera.
To traverse the menu, press CALL + UP/DOWN keys to move up/down, CALL + RIGHT/LEFT to
change value or to move left/right, and CALL + ENTER to select or enter submenu.
4.5.1 Dome Connection
Follow the steps to install dome camera.
•
See
2.4 Rear Panel Connectors
for RS-485 port pin definition.
•
Connect the R+, R- terminals on the dome camera to the D+, D
−
terminals on the RS-485
port by RS-485 cable respectively. Refer to the connection figure illustrated in
2.4 Rear
Panel Connectors
.