-
27
-
3.6.3 Per Camera Configuration
This function is used to set the Day / Night / Weekend PPS (Picture per Second) and Quality
for each channel. The Preset Configuration must be set to <OFF> for accessing these schedules.
The menu is displayed as below (Record Mode: 720×240@120PPS in NTSC / 720×288@100PPS
in PAL).
Per Camera Config
Cameral Select
Normal PPS
Normal Qlty
Event Max PPS
Event Qlty
Event Act
Day
7.5
Mid
30
Best
Both
Night
7.5
Mid
30
Best
Both
CH1
Weekend
7.5
Mid
30
Best
Both
•
First, select a Camera for setting its record configuration. The image and recording settings
from the selected camera will be displayed on the screen.
•
Move the cursor using Direction keys and press ENTER to select an item.
•
Change the value using UP / DOWN keys.
•
Press ENTER to confirm the settings or ESC to abort.
•
Press ESC to return to Record Setup menu.
Please note that the total normal PPS for all channels cannot exceed 120 NTSC
(720×240@120PPS) / 100 PAL (720×288@100PPS). To increase one channel’s PPS, others’ may
have to be reduced first. Event PPS is not restricted to this rule, since a smart event scheduler will
handle the total PPS with a correct weighting.
3.6.4 Record Event Video Only
If the DVR shall start recording only when alarms are triggered, follow the steps below:
•
Enter the OSD setup menu with correct password.
•
In the OSD setup menu, select <Record Setup> menu. Move the cursor to the item <Preset
Config>, and select <Event only>.
Refer to OSD Setup Manual, Section
Preset Record Configuration
for further information.
3.6.5 ezRecord Setup
This item aims to ease the complicated record settings, and to make the setup much easier.
Note that the item can be reached only when <ezRecord> is selected as the option for <Preset
Config>.
Select <ezRecord Setup> from <Record Setup> and press ENTER, the sub-menu appears as
below figure:
