Planet FPS-3300, User Manual, Page: 59 / 71

10. Upgrading Print Server
Upgrading print server will allow you to upgrade its firmware inside the print server while the newer software
version of the print server is available from your local dealer. Depending on the different systems users might
use, this chapter is divided into several Sections; please refer to the following lists for your systems.
1. Upgrading the print server from PSAdmin
2. Upgrading the print server from Windows NT/2000/XP/2003
3. Upgrading the print server from UNIX system
4. Upgrading the print server from WEB browser
Note: 1.Before you proceed to upgrade the print server, please ensure that the necessary binary file is located
on your current working directory.
2.Before upgrading the print server, ensure that it is not printing jobs. You have to wait until the print job
is finished before you can proceed.
3.Be careful not to interrupt the file transfer. If the transfer is interrupted, the print server may have to be
re-initialized by your dealer.
10.1 Upgrading the print server from PSAdmin
1. Log into your NetWare file server as a Supervisor (Admin.) or equivalent.
2. Ensure binary file is located in the PSAdmin directory.
3. Run PSAdmin from your Windows PC.
4. Click the Upgrade icon on tool bar.
10.2 Upgrading the print server from Windows NT/2000/XP/2003
1.
Ensure binary file is located in your current working directory.
2. At NT/2000/XP/2003’s DOS prompt, and type “ tftp –i <print server’s IP address> put mpsXX.bin “.
3. Wait for the transfer successful message.
4. Done.
10.3 Upgrading the print server from UNIX
1.
Log in as root
2. Ensure binary file is located in your current working directory.
3. Type “ tftp <print server’s IP address> ”.
4. At tftp prompt, type “ get upgrade ”.
5. Change to binary mode.
6. At tftp prompt, type “ put mpsXX.bin ”.
7. Wait for the file transfer to complete.
8. Quit from tftp.
59