3. MFP Server Installation in Windows 2000/XP
3.1 Hardware
Installation
1. Unpack the FPS-1010MG package and verify the items listed in the previous section are
provided.
2. Use USB cable to connect FPS-1010MG to the MFP or printer that you want to share to
your network.
3. Use a RJ-45 cable to connect the FPS-1010MG to your LAN or WAN.
4. Connect dipole antenna to FPS-1010MG antenna connector.
5. Connect the bundled power adapter to FPS-1010MG. The MFP Server will perform the
Power-On-Self-Test (POST) after power on. Please wait for 20 seconds.
Note:
1. Please use the power adapter which bundled with MFP Server. DO NOT use any other
power adapter from other sources. That may cause your FPS-1010MG damage.
2. To prevent the compatibility problem between FPS-1010MG and a few MFP or printer, it is
recommended that you power on the FPS-1010MG before the MFP or printer.
3.2 Software
Installation
Procedure
Before installation begin, please check your computer’s operating system. The operation
below is the installation of Windows 2000 SP4 and Windows XP SP1 or above. For the
installation procedures in Windows 98SE/Me/NT and other operating systems, please refer to
the other sections.
Note:
Some MFP printers will ask the user connect MFP to the PC directly and install the printer
driver, before MFP Server installation. That may cause the MFP Server installation adds one
more MFP (printer/scanner/fax/card reader) to your PC. You can delete the devices which the
MFP driver installed after MFP Server installation, or you can keep those devices exist in your
PC.
1. Insert User’s Manual and utility CD into the CD-ROM drive to initiate the autorun program.
Once completed a menu screen will appear.
2. Click on “MFP Server Utility” hyper link to initiate the installation. Or you can click the
“Start” button and choose “Run”. (Suppose “E” is your CD-ROM drive). When the dialog
box appears, enter “E:\Utility\Setup.exe” and press enter key. You will see the dialog box
as below. Please click “Next” to continue.
2
3. The “MFP Server Utilities - InstallShiled Wizard” is displayed, click "Next".
