4. WEB CONFIGURATION
The Web Smart Ethernet Switch provides a Web interface for Switch Smart function configuration. Since the Switch can be
configured through the Web Browser, a network administrator can manage and monitor the Switch from the local LAN or from
the Internet. Before login the Web interface of Switch, please setup the "IP Address" with local serial console port (RS232
port) and use this IP address to configure Switch through the Web interface. Or modify your PC's IP domain to the same with
Switch then use the default IP address to remote configure Switch through the Web interface.
4.1 Login in to the Switch
Before you start configure the Switch, please note the Switch is configured through an Ethernet connection, make sure the
manager PC must be set on same the IP subnet address. For example, the default IP address of the Switch is 192.168.0.100,
then the manager PC should be set at
192.168.0.x
(where x is a number between 1 and 254, except 100), and the default
subnet mask is
255.255.255.0.
Use Internet Explorer 5.0 or above Web browser. Enter IP address
http://192.168.0.100
(the
factory-default IP address) to access the Web interface. The login screen in figure 4-1 appears.
Figure 4-1
Web login Screen
Note:
The default mode is username
"admin"
without password.
4.2 Main Menu
After entering the username and password, the main screen appears as figure 4-2.
