Test the scenario:
1. Pick up the telephone set on ATA-150S port 1, and you should be able to hear the dial-tone
2. Press the keypad:
192*168*0*1**5061#
shall be able to connect to the ATA-150S port 2
3. Then the telephone set in ATA-150S port 2 should ring. Please repeat the same dialing steps
on port 2 to establish the first voice communication from ATA-150S
y
If the IP address of the remote calling party is known,
L
Hint
you may directly make calls via its IP address and end
with a “
#
”.
y
If the ATAs are installed behind a NAT/firewall/IP
sharing device for Peer-to-Peer VoIP application,
please make sure the NAT device support SIP
applications, and suitable settings should be applied
to the NAT device to enable the SIP communications
before making calls
y
[
ATA-150S
] in PLANET ATA series products, to connect
to remote ATA, press the keypad in the following
sequence to connect to the remote ATA-150S port 2:
[remote ATA IP address]**5061
, for example:
192*168*0*2**5061
Case 3: SIP Proxy mode
Number: 100
Number: 200
ATA-A
LAN IP address
(192.168.0.1)
ATA-B
LAN IP address
(192.168.0.2)
IPX-2000 (or IPX1900)
LAN IP address
(192.168.0.50)
STEP 1:
Log in IPX-2000 (or IPX-1900) and create two testing accounts/password:
100
/
123
(for
ATA-A), and
200
/
123
(for ATA-B) for the voice calls.
STEP 2:
Please log in ATA-A via web browser, find to the
SIP
item. In the setting page, please insert
the account/password information obtained from your service provider (in this sample, we’re
using PLANET IPX-2000 (or IPX-1900) as the IP PBX server for SIP account, call
authentications), and then the sample configuration screen is shown below:
-
42
-
