The following table describes the parameters of this page:
Field
Description
IP Address
Enter the IP address of LAN interface. It is
recommended to use an address from a block that
is reserved for private use. This address block is
192.168.1.1- 192.168.255.254.
Subnet Mask
Enter the subnet mask of LAN interface. The
range of subnet mask is from
255.255.0.0-255.255.255.254.
Secondary IP
Select it to enable the secondary LAN IP address.
The two LAN IP addresses must be in the different
network.
Link Speed/Duplex Mode
Select the Link Speed/Duplex Mode which you
need.
ETHERNET Status Table
This table will show the current link mode for every
port.
MAC Address Control
If you want to use the MAC address control
feature, select it and add the MAC address.
New MAC Address
Add the MAC address which you want can access
the router via the LAN port.
Current Allowed MAC
Address Table
This table will show the current allowed MAC
address .
3.4.1.2 IPv6 LAN Config
This page is used to configure the ipv6 Lan setting. You can set Lan RA server work mode
and Lan DHCPv6 server work mode.
The following table describes the
RA setting
parameters of this page:
27
