Field
Description
Delete Selected
Select a row in the
Static Route T able
and click it
to
delete the row.
Show Routes
Click it, the
IP Route Table
appears. You can view a list
of destination routes commonly accessed by your
network.
Static Route Table A list of the previously configured static IP routes.
Click
Show Routes
, the page shown in the following figure appears. The t able shows a
list of destination routes commonly accessed by your network.
3.6.2.2 RIP
Click
RIP
in the left pane, the page shown in the following figure appears. If you are using
this device as a RIP-enabled router to communicate with others using Routing Information
Protocol (RIP), enable RIP. This page is used to select the interfaces on your devices that
use RIP, and the version of the protocol used.
The following table describes the parameters and buttons of this page:
Field
Description
RIP
Select
Enable
, the router communicates with other
RIP-enabled devices.
Apply Change Click it to save the settings of this page.
Interface
Choose the router interface that uses RIP.
Receive
Version
Choose the interface version that receives RIP messages. You
can choose
RIP1
,
RIP2
, or
Both
.
Choose
RIP1
indicates the router rece ives RIP v1
messages.
Choose
RIP2
indicates the router rece ives RIP v2
messages.
Choose
Both
indicates the router re ceives RIP v1 and RIP
v2 messages.
Send Version The working mode for sending RIP messages. You can choose
RIP1
or
RIP2
.
45
