Field
Description
idle timeout time. Within the preset minutes, if the router
does not detect the flow of the user continuously , the
router automatically disconnects the PPPoE connection.
Bridge
You can select
Bridged Ethernet
,
Bridged PPPoE
, or
Disable Bridge
.
AC-Name
The accessed equipment type.
Service-Name
The service name.
802.1q
You can select
Disable
or
Enable
. After enable it, you
need to enter the VLAN ID. T he value ranges from 0 to
4095.
Apply Changes
Click it to save the settings of this page temporarily.
Return
Click it to return to the
Channel Configuration
page.
Undo
Click it to refresh this page.
3.4.2.2 ATM Setting
Click
ATM Setting
in the left pane, the page shown in the following figure appears. In this
page, you can configure the p arameters of the ATM, including QoS, PCR, CDVT , SCR,
and MBS.
The following table describes the parameters of this page:
Field
Description
VPI
The virtual path identifier of the ATM PVC.
VCI
The virtual channel identifier of the ATM PVC.
QoS
The QoS category of the PVC. Y ou can choose
UBR
,
CBR
,
rt-VBR
, or
nrt-VBR
.
PCR
Peak cell rate (PCR) is the maxi mum rate at which cells can be
transmitted along a c onnection in the A TM network. It s value
ranges from 1 to 65535.
CDVT
Cell delay variation tolerance (CDVT) is the amount of delay
permitted between ATM cells (in microseconds). Its value ranges
from 0 to 4294967295.
SCR
Subtain cell rate (SCR) is the maximum rate that traffic can pass
over a PVC without the risk of cell loss. Its value ranges from 0 to
65535.
MBS
Maximum burst size (MBS) is the maximum number of cells that
can be transmitted at the PCR. Its value ranges from 0 to 65535.
33
