Command Guide of WGSW-48040HP
pdcheck
Allows user to enable or disable per port PD Alive Check function.
IP
To set PoE device IP address here for system making ping to the PoE device.
<ipv4_addr>
<ipv4_addr>
Default:
N/A
Usage Guide:
To configure
Ping PD IP Address
of
PoE
for specific interface
Example:
To configure
Ping PD IP Address
(10.101.10.10) of
PoE
for
GigabitEthernet X/X.
Switch# configure terminal
Switch (config)#
interface GigabitEthernet X/X
Switch (config-if) #
poe pdcheck IP 10.101.10.10
4.2.45.70 poe pdcheck action
Command:
poe pdcheck action { reboot | alarm | reboot-alarm }
poe
Power Over Ethernet.
pdcheck
Allows user to enable or disable per port PD Alive Check function.
action
Allows user to set which action will be applied if the
PD is without any response
alarm
It means system will issue an alarm message via Syslog, SMTP.
reboot
It means system will reset the PoE port that is connected to the PD.
reboot-alarm
It means system will reset the PoE port and issue an alarm message via Syslog, SMTP.
Default:
N/A
Usage Guide:
To configure
PD Ping Alive Check Action
of
PoE
for specific interface
Example:
To configure
PD Ping Alive Check Action (Alarm)
of
PoE
for
GigabitEthernet X/X.
Switch# configure terminal
Switch (config)#
interface GigabitEthernet X/X
Switch (config-if) #
poe pdcheck action alarm
-105-
Summary of Contents for WGSW-48040HP
Page 1: ......
