you should have a setting in Wireless Bridge MAC. Enter
the MAC address of target access point. Moreover, the
target access point must be "WDS" or "AP+WDS" as well.
Description
Enter the Comment of station.
Current Wireless Bridge Information
You can see the basic information of all wireless bridge
devices. And you can delete any wireless bridge in the list.
3.6 Advanced
This tab is used to set up the AP’s advanced wireless functions. These settings should only be
adjusted by an expert administrator as incorrect settings can reduce wireless performance.
Parameter Descriptions
Beacon Interval
This value indicates the frequency interval of the beacon. A beacon is a packet
broadcast by the wireless AP to keep the network synchronized. A beacon
includes the wireless LAN service area, a time stamp, Delivery Traffic Indicator
Maps, and the Traffic Indicator Message (TIM). The default value is 100.
RTS Threshold
This value should remain at its default setting of 2,347. Should you encounter
inconsistent data flow, only minor modifications are recommended.
DTIM Interval
This value indicates how often the Access Point sends out a Delivery Traffic
Indication Message (DTIM). Lower settings result in more efficient networking,
while preventing your PC from dropping into power saving sleep mode. Higher
settings allow your PC to enter sleep mode, thus saving power, but interferes
with wireless transmissions.
Transmit Rate
The “Transmit Rate” is the transmit data rate limitation for this wireless AP. The
21