54-312
Example:
Switch(config)#mrpp ring 100
54.13 mrpp ring primary-port
Command:
mrpp ring <
ring-id
> primary-port
no mrpp ring <
ring-id
> primary-port
Function:
Specify MRPP ring primary-port.
Parameter:
<ring-id>
is the ID of MRPP ring; range is <1-4096>.
Command Mode:
Port mode
Default:
None
Usage Guide:
The command specifies MRPP ring primary port. Primary node uses primary port to send Hello packet, secondary
port is used to receive Hello packet from primary node. There are no difference on function between primary port and
secondary of secondary node.
The mrpp enable command must be enabled before the control-vlan command be used. If primary port, secondary
port, node-mode and enable commands all be configured after control-vlan, then the mrpp-ring function is enabled.
Example:
Configure the primary of MRPP ring 4000 to Ethernet 1/1.
Switch(Config)#interface ethernet 1/1
Switch(config-If-Ethernet1/1)#mrpp ring 4000 primary-port