40-150
Parameters:
<
name
>
is the name of the access list. The name can be formed by non-all-digit characters of length of 1 to 32.
Command Mode:
Global Mode.
Default:
No access list is configured by default.
Usage Guide:
When this command is issued for the first time, an empty access list will be created.
Example:
To create a standard IP access list name ipFlow.
Switch(config)#ip access-list standard ipFlow
40.12 ipv6 access-list
Command:
ipv6 access-list
<num-std>
{deny | permit} {
<sIPv6Prefix/sPrefixlen
> | any-source | {host-source
<sIPv6Addr>
}}
no ipv6 access-list
<
num-std>
Functions:
Creates a numbered standard IP access-list, if the access-list already exists, then a rule will add to the current
access-
list; the “
no access-list {
<num-std>|<num-ext>
}
“command deletes a numbered standard IP access-list.
Parameters:
<num-std>
is the list number, list range is between 500
～
599;
<
sIPv6Prefix>
is the prefix of the ipv6 source address;
<sPrefixlen>
is
the length of prefix of the ipv6 source address,
range
is between 1
～
128; <sIPv6Addr> is the ipv6
source address.
Command Mode:
Global Mode.
Default:
No access-list configured.