11-213
Usage Guide:
Detect the errored frame number of the port after the time of specific detection period. If the number of errored frame
is larger than or equal to the threshold, bring the corresponding event and notify the peer through OAMPDU.
Example:
Configure the detection period of errored frame event on port1/4 to be 20s.
Switch(Config-If-Ethernet1/4)#ethernet-oam errored-frame window 100
11.10 ethernet-oam errored-frame-period threshold high
Command:
ethernet-oam errored-frame-period threshold high {<
high-frames
> | none}
no ethernet-oam errored-frame-period threshold high
Function:
Configure the high threshold of errored frame period event, no command restores the default value.
Parameters:
<
high-frames
>
, the high detection threshold of errored frame period event, ranging from 2 to 4294967295.
none
, cancel the high threshold configuration.
Command Mode:
Port mode
Default:
none.
Usage Guide:
During the specific detection period, serious link event is induced if the number of errored frame is larger than or
equal to the high threshold and the device notifies the peer by sending Information OAMPDU of which the value of
Link Fault flag in Flags field is 1. Note that the high threshold can not be less than the low threshold.
Example:
Configure the high threshold of errored frame period event on port 1/4 to be 3000.
Switch(Config-If-Ethernet1/4)#ethernet-oam errored-frame-period threshold high 3000