4 System Configuration
This section describes how to configure system parameters used by IP PBX. Click
Customize Setup
after login the web interface to configure the following system parameters.
4.1 PBX System
The
PBX System
page briefs IP PBX status to the administrator. Firmware versions, IP addresses of
WAN and LAN interfaces, and default gateway router are shown in this page. Click
PBX System
to
see the basic information of IP PBX.
4.2 Time Setup
The
Time Setup
page allows administrator to configure time zone and date for IP PBX. With correct
time setup, functions such as IVR, worktime, and voicemail can present the actions at the right time.
Select
System
->
Time Setup
to see the current setting of time zone and date.
4.2.1
System Time Zone
1.
Click a region/country in the
Time Zone
list.
2. Click
Apply
in
System Timezone Setup
.
3. Go
to
System
->
Shutdown
, select
Rebooting After Shutdown
and Click
Yes
to activate
changes.
4.2.2
Real Time Clock (RTC) Setup
1.
Click year, month, day, hour, minute, and second in the correspondent list.
2. Click
Apply
in
Real Time Clock Setup
.
Note:
When reset the time 15 minutes later than the time showed in RTC Setup, the system will ask for
re-login.
4.3 On-board WAN Setup
The
On-board WAN Setup
page allows administrator to configure WAN network interface for IP PBX.
Select
System
->
On-board WAN Setup
, and the current setting of WAN network interface is
displayed, e.g. type, IP address etc.
22