720p SIP Multi-unit Apartment Vandalproof Door Phone with RFID & PoE
HDP-5260PT
29
Service Port Settings
Web Server Type
Specify Web Server Type – HTTP or HTTPS
HTTP Port
Port for web browser access. Default value is 80. To enhance security, change
this from the default. Setting this port to 0 will disable HTTP access.
For example, the IP address is 192.168.1.70 and the port value is 8090, the
accessing address is http://192.168.1.70:8090.
HTTPS Port
Port for HTTPS access. Before using https, an https authentication certification
must be downloaded into the equipment.
Default value is 443. To enhance security, change this from the default.
Telnet Port
Port for Telnet access. The default is 23.
RTP Port Range Start
Set the beginning value for RTP Ports. Ports are dynamically allocated.
RTP Port Quantity
Set the maximum quantity of RTP Ports. The default is 200.
1.
Any changes made on this page require a reboot to become active.
2.
It is suggested that changes to HTTP Port and Telnet ports be values greater than 1024.
Values less than 1024 are reserved.
3.
If the HTTP port is set to 0, HTTP service will be disabled.
3.3.2 QoS & VLAN
The equipment supports 802.1Q/P protocol and DiffServ configuration. Use of a Virtual LAN (VLAN) allows
voice and data traffic to be separated.
Chart 1 shows a network switch with no VLAN. Any broadcast frames will be transmitted to all other ports.
For example, frames broadcast from Port 1 will be sent to Ports 2, 3, and 4.
Chart 2 shows an example with two VLANs indicated in red and blue. In this example, frames broadcast
from Port 1 will only go to Port 2 since Ports 3 and 4 are in a different VLAN. VLANs can be used to