720p SIP Multi-unit Apartment Vandalproof Door Phone with RFID & PoE
HDP-5260PT
16
2.2 Hardware Installation
The HDP-5260PT is constructed of four parts as shown below. Prior to the installation, the installer is required
to remove the front panel of the HDP-5260PT for wall mounting. Please follow the steps below for the
installation.
Figure 1 Four Major Parts of HDP-5260PT
Step 1: Installation Preparation
A. Check the following contents:
Hex wrench x 1
RJ45 plugs x 2 (1 spare)
TA5 x 40mm screws x 5 (1 spare)
35mm screw anchors x 5 (1 spare)
M4 x 16mm screw x 1 (spare)
PM3 x 16mm screw x 1 (spare)
B. Tools that may be required:
Hex wrench
Phillips screwdriver (Ph2 or Ph3), hammer, RJ45 crimper
Electric impact drill with an 8mm drill bit.