Planer ShipsLog 3, User Manual

Page: 7 / 47

7
Important information
1.3 Symbols used on the equipment
Refer to these instructions and those of the dry shipper. Failure to follow these
instructions may result in personal or third-party injury.
Consult instructions for use. This includes these instructions and those of the
dry shipper.
Manufacturer
1.4 Safety instructions
·
Refer to the dry shipper's documentation for safety and operation
instructions.
·
The surfaces of the dry-shipper lid (cork) and the sensor will be extremely
cold when removed from the dry shipper.
o
Cold surfaces can cause frostbite.
o
Always wear cryogenic gloves when handling cold parts.
·
There are no user serviceable parts. With the exception of replacement of
the data logger's battery, all servicing must be undertaken by trained and
authorised personnel.
·
The data loggers contain a 3.6 V, ½ AA lithium primary battery.
·
Do not open, puncture or mutilate the batteries.
·
Do not heat batteries or attempt to recharge them.
·
Do not use a fire to dispose of batteries.
·
Keep batteries out of the reach of children.
·
Always remove old, weak, or worn-out batteries promptly and recycle or
dispose of them in accordance with local regulations.
·
Remove the batteries if your device is to be stored for longer than a month
without being used.
1.5 Introduction
The ShipsLog 3 (SL3) allows temperature measurements to be recorded from a dry
shipper. The SL3 comprises a modified cork with a protective data logger housing
mounted to the top and a thermocouple sensor located on the tip of the cork.