Planar WN-5040-720, User Manual

Page: 94 / 153

83
LEDs in Margay
When the LED is…
LED Name Off Green Amber Red
Ready
Lamp is on (or no
power)
Source Source absent Valid source present
Source absent or not
valid
Lamp Lamp off Lamp on Lamp striking Lamp failed
Fan Fan off Fan is running
Fan failed recently, but
is now running
Fan failed
Lamp disabled
Remote IR Not receiving IR now Receiving IR radiation
Door Open (refers to
rear panel and elec-
tronics module door)
No power to electron-
ics
Door closed & rear
panel closed
Lamp enabled
Either door was open,
now closed
Must cycle AC power
to reset and enable
lamp
Either door open
Lamp disabled
Serial Data
No command received
Received any com-
mand
Serial Cmd
Received command
“meant for me”
Lamp Saver
Lamp Saver not active
or lamp is off
Lamp Saver active
Source present
Lamp on
Active
Lamp is cooling
Source present
Lamp will come on
when cooled
Active
Source absent
Lamp off
Optical Engine Status Optical engine OK
Optical engine fault or
communication fail-
ure
Ballast Status
1
1. At this writing, Ballast Status LED is not implemented, so it is always off.
Lamp off Lamp on
Ballast fault or com-
munication failure
Ballast Supply
2
2. At this writing, Ballast Supply LED will show Red state only briefly.
High voltage (HV) off HV on and ready HV on but not ready
Had to wait more than
10 seconds for ready
state