Planar Clarity MX46HD, Quick Start Manual

Page: 9 / 36

Safety Information
Clarity Matrix Video Wall Quick Start Guide 3
10
Only use the attachments/accessories specified by the manufacturer.
11
Unplug all Clarity Matrix LCD Video Wall products during lightning storms or
when unused for long periods of time.
12
You must follow all National Electrical Code regulations. In addition, be aware of
local codes and ordinances when installing your system.
13
Refer all servicing to qualified service personnel. Servicing is required when any
of the Clarity Matrix LCD Video Wall products have been damaged in any way,
such as the AC power cord or plug is damaged, liquid has been spilled or objects
have fallen into a product, the products have been exposed to rain or moisture,
do not operate normally or have been dropped.
14
Keep the packing material in case the equipment should ever need to be
shipped.
15
Wall mounts must be secure. The wall must be strong enough to hold all LCD
modules, brackets and cables. Each MX46HD weighs about 39lbs (17.7kg) and
each MX55 LCD module weighs about 50lbs (23kg). With protective optically
bonded glass, the MX46HD LCD module weighs about 49lbs (22.2kg) and the
MX55 LCD module weighs about 65lbs (29kg).
16
Slight pressure on the LCD will cause distortion of the image. Heavier pressure
will cause permanent damage. Clarity Matrix Video Walls should be mounted
where viewers cannot touch the screen or insert small objects in the openings
that will create hazards by contacting bare conductive parts.
Caution: The front polarizer is soft and subject to scratches from sharp objects.
17
The polarizer is a thin sheet of film laminated to the outside layer of glass on the
LCD screen. Take care when handling items near the screen.
Caution: This product contains a lithium battery. There is a risk of explosion if the battery is
replaced by an incorrect type. Dispose of the battery according to the instructions on the
next page.
Important EMC Information
In order to meet Electromagnetic Compatibility (EMC requirements), the installer will
need to add one clip on ferrite bead to the 24VDC power cable near each LCD.