Pixsys DRR 245, Start Manual

Page: 44 / 59

44 - DRR245 - User manual
59
op.mo.
Operating Mode
Select operating mode. (Par. 8.7 pag. 18) (Par. 9.2 pag. 23)
cont.
Controller ( Default )
pr.cY.
Pre-programmed cycle
2t.s.
Setpoint change by digital input
2t.s.i.
Setpoint change by digital input with impulse command
3t.s.i.
3 sets change by digital input with impulse command
4t.s.i.
4 sets change by digital input with impulse command
t.res.
Reset time (custom function)
p.c.s.s.
Pre-programmed cycle with Start / Stop only by digital input
60 au.ma. Automatic / Manual
Enable automatic / manual selection
(Par. 8.6 pag. 18)
dis.
Disabled ( Default )
En.
Enabled
En.St.
Enabled with memory
61
dGt.i.
Digital Input
Digital input functioning (P59 selection must be
cont.
or
Pr.cY.
) (Par. 9.2
pag. 23)
dis.
Disabled ( Default )
st.st.
Start / Stop
rn.n.o.
Run N.O. (enables regulation with N.O. contact)
rn.n.c.
Run N.C. (enables regulation with N.C. contact)
L.c.n.o.
Lock conversion N.O. (stop conversion and display value with
N.O.)
L.c.n.c.
Lock conversion N.C. (stop conversion and display value with
N.C.)
tune
Manual Tune (by digital input)
a.ma.i.
Automatic / Manual Impulse (if enabled on parameter 60)
a.ma.c.
Automatic / Manual Contact (if enabled on parameter 60)