20 - DRR245 -
User manual
8.8
Memory Card (optional)
Parameters and setpoint values can be duplicated from one controller to
another using the Memory card.
2 modes are available:
•
With the controller connected to the power supply
.
Insert memory card
when the controller is off
.
On activation display 1 shows
memo
and display 2 shows
---
(
only if the correct
values are saved in the memory card
). By pressing
c
key display 2 shows
Load
,
then confirm using
|
key. Controller loads the new value and restarts.
RED LIGHT: waiting for programming
GREEN LIGHT: done
LED ROSSO: accceso in programmazione
LED VERDE: programmazione eseguita
•
With the controller not connected to power supply.
The memory card is equipped with an internal battery with an autonomy of
about 1000 uses (2032 button battery, replaceable).
Insert the memory card and press the programming buttons.
When writing the parameters, led turns red and on completing the procedure it
changes to green. It is possible to repeat the procedure without any particular
attention.
Updating Memory Card
To update the memory card values, follow the procedure described on first
mode, setting display 2 to
----
so as not to load the parameters on controller
1
.
Enter configuration and change at least one parameter.
Exit configuration. Changes are stored automatically.
1
If on activation the controller does not display
memo
it means no data have been saved on the
memory card, but it is possible to update values.
Summary of Contents for DRR 245
Page 1: ...Start guide DRR245 Controller...
Page 2: ......
Page 5: ......
Page 56: ...56 DRR245 User manual...
