1
T
rouble
-
Shoo
ting
Bef
o
re
Using
Initial
Se
tting
s
Conne
c
ting
T
h
e W
ire
s
Inst
alling
T
h
e Pr
o
d
u
c
t
Ho
w
t
o
Op
e
ra
te
F
e
a
ture
s
3-drive
PRO
P
r
E
POWER
RESPONSE
ECO
3-drive
PRO
P
r
E
POWER
RESPONSE
ECO
3
-
drive
PRO
User’s Manual
(This Book)
Please check the contents of the package
Contents
Controller
[65 × 26 × 13.5 (D) mm]
Unit
[
50 × 22 × 70 (D) mm
]
Zip Ties
(Large) × 2
(Small) × 2
Throttle Controller
Part Names
Display
1
SET Switch
2
MODE Switch
3
• Switching Modes
• Mode Display
• Degree of
Acceleration Display
(5–100%)
• Display Each Settings
Double-sided Tapes
[45 × 14mm] × 2
[25 × 35mm] × 1
L-shaped Fastener
(3DP As of July, 2018 No.2)
Thank you for purchasing PIVOT product.
Please read this manual carefully and keep it for future reference.
USER’S MANUAL
Product
If this product is given to another
user, make sure to include this
User’s Manual.
Product Number :
3DP
(
)
Before Using / Contents
………………………………………
1
Part Names
……………………………………………………
1
Features
…………………………………………………………
2
procedure
1
Connecting The Wires
…………………………
3
procedure
2
Installing The Product
…………………………
3
procedure
3
Initial Settings
(Degree of Acceleration Setting)
……
4
How to Operate
…………………………………………………
5
Display Items
……………………………………………………
6
Troubleshooting
………………………………………………
7
• For Adjusting the Change
Ratio for each Mode
• Initial Settings
Turning off the Display
Note: This product is interlocked
with the ECU (engine computer)
power. Depending on the model of
car, the display may remain on for
up to 15 minutes even after the
ignition has been turned off; this is
normal.
After installation, make sure to carry out “Initial Settings” .
After having installed this product, make sure to make settings for your car’s special characteristics by carrying out the
“Initial Settings” on Page 4. If the “Initial Settings” are not carried out, a
Check Engine Light
may go on. Also, the unit
will remain in
NORMAL Mode
even if the Mode is switched.
Worried about Installation?
If you are worried about carrying out wiring or other installation procedures please consult your dealer.
Do not install this product if the ECU is not the original one or when a sub-ECU from other companies is being used.
Only use with Manufacturer’ s Original ECU.
When uninstalling the product, make sure to return it to NORMAL Mode before carrying out any work. Reconnecting this
product in a different mode may cause the Check Engine Light to come on.
Set to NORMAL Mode upon Removal of Product.
Under no circumstances should modifications or changes be made to this product. Doing so may cause damage not only to the
product, but to the car and the operation of the car in which it is installed.
Modifying this Product is Forbidden.
Only use 3-drive Specialized Harness.
Using another type of harness will cause troubles and failure; use only the 3-drive specialized harness.