M0502
22
/28
Installaltion, use and maintenance
13.9 METER CONFIGURATION
The METER feature a menu with which the user can select the main measurement unit, Quarts (Qts),
Pints (Pts), Litres (Lit), Gallons (Gal); The combination of the unit of measurement of the Partial
register and that of the Totals is predefined according to the following table:
Combination no.
Unit of Measurement Partial Register
Unit of Measurement Totals Register
1
Litres (L)
Litres (L)
2
Gallons (Gal)
Gallons (Gal)
3
Quarts (Qts)
Gallons (Gal)
4
Pints (Pts)
Gallons (Gal)
To choose between the 4 available combinations:
1
Wait for the METER to go to Standby
2
MODE
+
Then press the MODE and RESET keys together. Keep these pressed
until the word “UNIT” appears on the screen together with the unit of
measurement set at that time (in this example Litres / Litres )
3
Every short press of the RESET key, the various combinations of the
units of measurements are scrolled as shown below:
Gal
Qts
Pts
Gal
RESET
RESET
RESET
4
MODE
MODE
MODE
By pressing the MODE key at length, the new settings will be stored,
the METER will pass through the start cycle and will then be ready to
dispense in the set units.
ATTENTION
The Reset Total and Total registers will be automatically changed to the
new unit of measurement.
NO new calibration is required after changing the Unit of Measurement.
