Pitney Bowes Relay 1000, Operator'S Manual

Page: 21 / 64

System Setup • 2
2-5 SV63176 RevB
Loading the Sheet Feeders (Feeders A1 and A2)
• Sheet Feeder A1 is common to all models and located below Manual
Feeder M.
• Sheet Feeder A2 is an option on all models. It allows the system to
insert a second folded sheet into an envelope.
• Both feeders are used for sheets that require folding before inserting.
• Load both feeders in exactly the same way.
1. Always fan (aerate) sheets before
you load them. This prevents
them from sticking together.
2. Tap the stack of sheets onto a
firm surface to align the edges.
3. Place the sheets into Sheet
Feeder A1 or A2 as required.
IMPORTANT! Always load sheets into
these feeders face down and bottom
edge first. The bottom edge of the
sheet is furthest into the system.
NOTE: If you use Sheet Feeders A1 and A2 at the same time, you must
load the document printed with the address into Sheet Feeder A2. If you
load the address-bearing document into Sheet Feeder A1, the address
will not be visible in the envelope window.
4. Slide the back stop in until it just
touches the paper stack.