Pitney Bowes Epic, Manual

Page: 167 / 295

Auto Adjustments
The most common adjustments in the Epic Inserter engine are adjusted automatically based on mode
settings and entries the operator makes in DC. These default adjustments settings will be sufficient for
most standard material but occasionally minor adjustments are needed. These minor adjustments can be
made manually in the Engine Setup screen.
Note:
Areas of the Epic Inserter that auto adjust are identified in the Job Changeover Guidelines section.
Auto Adjust Settings
Auto adjust settings are based on mode settings and entries operators make in DC.
Pocket Settings
The entrance nip rollers and the pocket stops adjust to the length of the envelope entered in the mode.
Both the
pocket width offset and pocket center offset settings can be manually adjusted in the
Engine Setup screen.
Horns Settings
The horns adjust to be centered on the envelope. The width of the horns uses the widest measurement
of either the envelope or material on the chassis to set the horns. The
horn width offset setting can be
manually adjusted in the Engine Setup screen.
Insert Blower Offset
The amount of vacuum on the vacuum deck can be increased or decreased. It is not normally necessary
to change this setting but it can be manually adjusted in the Engine Setup screen if needed.
Backwall Settings
The backwall adjusts based on the depth of the envelope, to set the crease line of the envelope
consistent with the sealer brush (which stays in a fixed position). The
backwall offset position setting
can be manually adjusted in the Engine Setup screen.
Job Changeover Guidelines
Pitney Bowes Epic Select Operator Guide December, 2017 Page 161 of 288