Adjusting Chassis Material Center Deck Control Straps
Chassis material control straps are located in front of each feeder and they support the collation as it
travels down the length of the chassis. The straps are adjusted to provide the proper amount of pressure
on each mailpiece and to center the collation when the chassis stops.
To adjust the material control straps:
1. Start the inserter and run a job.
2. When the chassis deck is full, stop the machine with the remote or using DC.
3. View the collations / mailpieces resting underneath each feeder.
a. If collation / mailpiece is more than 1-inch away from the pushers, loosen the lockdown screw
with the Operator setup tool and rotate the indicator lever to the
right
to
tighten
strap pressure.
b. If the collation / mailpiece is buckled at the pusher, loosen the lockdown screw with the
Operator setup tool and rotate the indicator level to the
left
to
loosen
strap pressure.
Item Description
1
Lockdown Screw
2
Indicator Lever
Adjust Chassis Material Control Straps
4. Run more material and adjust the straps as needed until the proper position is achieved.
Operator Adjustments
Pitney Bowes
Epic Select Operator Guide
December, 2017
Page 108 of 288
Summary of Contents for Epic
