SDC965B DL400 Operator Guide
System Overview
Operation
EN
DL400 Introduction
The DL400 Letter Opener is a high speed envelope opener that can open and count
up to 400 envelopes per minute (processing speed depends on the length and
thickness of mail).
Cut/No Cut Function
The DL400 Letter Opener is able to count mail with or without cutting open the
envelope. This function can be selected by turning the
Cut/No Cut Knob
to the
desired position.
Counter Function
The counter displays the count for individual mail pieces processed whether in the
Cut
or
No Cut
mode. If the machine is turned off (or power is lost), the count total
will be saved. Once the counter reset button is pressed, the previous count is lost.
The accuracy of the count can be affected by the condition of the mail and machine.
For a more accurate count a maximum stack height of 4cm is recommended.
System Components DL400
Power
On/Off
Switch
Envelope Feed
Hopper
Indicator Panel* Cut/No Cut
Selector
Knob
Cutter
Adjustment
Lever
Envelope
Catch Tray
Upper
Transport
Cover
Chip bin
DL400 Operation
Before commencing operation, please read the Safety document supplied with your
system.
1. Make sure the power cord is connected to the DL400 and the plug is securely
connected to the power receptacle.
NOTE:
When first connected the
Chip Bin Full
indicator light will flash. Removal
and Replacement of the
Chip Bin
resets the indicator.
2. Select either the ‘No Cut’ or ‘Cut’ position on the
Cut/No Cut Selector Knob
as
required. See section
Cut/No Cut Function
for more information.
3. Set the
Cutter Adjustment Lever
to deep or shallow cut as required. This is
simply achieved via the lever. However, the cut depth can also be adjusted as
described in
Cutter Adjustment
in this document.
4. Press the
Counter Reset
button to reset the counter (if desired).
5. Load mail (approximately 50 pieces) onto the
Envelope Feed Hopper
. Ensure
that the mail is oriented with the side of the mail to be cut, against the back of
the
Feed Hopper
(See image below).
6. To begin operation turn the
On/Off Power Switch
to the On position.
7. Once the
Envelope Feed Hopper
is empty, empty the
Envelope Catch Tray
.
8. To continue processing, repeat the above steps.
*NOTE: Indicator Panel
includes;
Chip Bin Full
Indicator, Counter Indicator
Window and Counter Reset
Button, See image far right.
Loading Mail
Indicator Panel
Chip Bin Full
Indicator Light
LED Counter
Indicator
Window
Counter Reset
Button
Cutter
Adjustment
Lever
Cut/No Cut
Selector
Knob
Upper
Transport
Cover Latch
