PITBULL X24-36, Operator'S Manual

Page: 34 / 71

34
8.2 Service areas
WARNING! Always turn off the engine and allow the engine and exhaust system to cool
down before opening a service area, making sure all service areas are closed before
starting the engine.
To make maintenance of the Pitbull easier, there are three service areas. The most accessible service
area is the engine area (1). This is accessible via both the right and left-hand sides of the machine.
These can be opened by turning the lock. Your Pitbull may be equipped with the option for locks on
hoods. Please note that this service area near the engine compartment may be locked.
To access the battery, there is a service space on the side
between the cabin and the engine compartment (2). To open it,
the seat backrest must be folded forward by pulling the lever on
the left-hand side of the seat upwards. The service hatch can be
opened by loosening the four bolts. Always make sure that the
battery isolator is off before opening this service area.
The drive can be reached via the service area under the seat (3).
To reach it, the bolts on the sides of the seat must be loosened.
There is one on each side. Once they are loosened, the entire
seat can be folded forward.
A number of parts can be serviced via the underside of the
machine. The underside of the machine is partly open, and under the combustion engine there is a
service hatch that can be opened by loosening four bolts. By opening the service hatch at the engine
compartment and the service compartment under the seat, much more light enters through the
underside of the machine to make servicing easier. When servicing via the underside, pay extra
attention that the machine is unable to roll or move.
8.3 Lubrication points
The following lubrication points should be lubricated:

Boom lifting cylinders

Boom breakout cylinder

Steering cylinder

Hydraulic quick coupling cylinder

All hinge points of the boom
8.4 Chassis bolt tightening torques
Nominal dimensions Spanner width (mm) Torque (Nm)
M5 8 6.5
M6 10 11.3
M8 13 27.3
M10 17 54
M12 19 93
M16 24 230
M20 30 464