From the detect distance 4m to 12m the detector with high sensitivity.
3.2 Installation steps
1. Disassemble:
B.Pull out the bottom of the cover
C.Remove the PCB
A. Loose screw
When power from external DC12V
Standby current
18mA
Alarm current
30mA
The green LED light on for 3s after power on,
then flash for 2s and light off.Then red
LED flash for 15s. 3 minutes after power on,
detector enter stable work status.
Alarm mode: Red LED light on for 3s.
Relay output: N.C
Wireless distance 150m
open air
Wireless frequency:433MHZ
Max current when recharge battery
120mA
Detect distance:12m
25
Power from buitl-in battery
Alarm current
18mA
Standby current
80uA
Low battery alarm when battery low voltage
it will report low voltage. And when battery
voltage recover,it will report battery
recover again
Relay output
N.O
If external power cut off
the backup battery will change the relay output
to N.O mode automatically 2 minutes after.
Viceversa when change from backup battery to
external power
P/N
20091014A03
D.Remove the middle-case
Surface
fixing
45
corner
fixing
D.Put the PCB back on the cover with clips and fasten screws.
C.Fix the base cover on the wall with two screws.
B.Draw the cable from back channel
A.Mark the drilling points and make holes.
FT-89R is the best indoor/outdoor motion detector with passive infrared and microwave.It's water proof and all weather resistant with two layer
stable housings..FT-89R combines a variety of detection techniques whichenable it to work in the most difficult environment where needs high
security while maintaining immunity to false alarm.The infrared sensor adopts nice lens produce three-dimensinal thermal imaging of the protected
area .Combinging the four-element microwave scanning contributes to an amazing detection capacity.Using this technique allows high sensitivity
but lowest false alarm.FT-89R is equipped with unique protection mechanisms against any attempt to damage or to disable its operation.
1.Introduction
Installation Guide of FT-89R
PIR & MW Intelligent Detector
3.Installation
3.1 Guide
Do not face to cold or heat source
Do not fact to sun light
Keep away from high-
voltage wire
Installation base
should be stable
Do not face to metal wall
2. Installation base
Suggest corner mount
ML-89DO
ML-89DO
ML-89DO
ML-89DO
