Piper Aircraft Corporation Malibu Mirage PA-46-350P, Airplane Maintenance Manual

Page: 66 / 1956

5-20-00
1D8
PIPER AIRCRAFT, INC.
PA-46-350P, MALIBU MIRAGE
MAINTENANCE MANUAL
5. Scheduled Maintenance (continued)
Inspection
NATURE OF INSPECTION Interval (Hrs)
50 100
PAGE 14
Feb 28/07
E. FUSELAGE AND EMPENNAGE GROUP (cont.)
CAUTION: THE FLUX DETECTOR IS SECURED TO THE MOUNTING BRACKET
WITH BRASS SCREWS. ENSURE ONLY BRASS SCREWS ARE
USED WHEN REINSTALLING.
41. Inspect flux detector .............................................................................................. O
42. Check outflow and safety valves
for cleanliness, looseness, and condition .............................................................. O
NOTE: Outflow and safety valves may require cleaning prior to 100 hour intervals,
if heavy smoking or dusty conditions exits.
43. Inspect all hoses and lines for leakage, condition, and security.
(See Note 15.) ....................................................................................................... O
44. Lubricate per Lubrication Charts, 12-20-00 .......................................................... O
45. Install inspection covers and panels...................................................................... O
NOTE: Ensure correct hardware is used when reinstalling vertical fin dorsal fairing
over flux detector.
F. LANDING GEAR GROUP
1. Check oleo struts for proper extension and evidence of fluid leakage.
(See Landing Gear, 12-10-00.) .............................................................................
O O
CAUTION: WHEN AIRCRAFT HAS OPTIONAL RADAR POD INSTALLED ON
RIGHT WING, ENSURE THAT JACK DOES NOT COME INTO
CONTACT WITH RADAR POD.
2. Place airplane on jacks. (Refer to 7-10-00.) .......................................................... O
3. Remove inspection covers and panels.................................................................. O
4. Inspect nose gear steering control and travel ....................................................... O
5. Inspect nose gear installation for condition and security.
(See Notes 27, 35 and 36.) ...................................................................................
O
6. Inspect nose gear trunnion for cracks and condition............................................. O O
7. Inspect nose wheel steering cam and rotator for cracks ....................................... O
8. Check squat switch for security and adjustment ................................................... O
9. Inspect tires for cuts, uneven or excessive wear, and slippage ............................. O O
10. Remove wheels and clean, check and repack bearings ....................................... O
11. Inspect wheels for cracks, corrosion, and broken bolts......................................... O
12. Inspect brake disc/linings for wear, condition, and security................................... O O
13. Check tires for proper pressure.
(Refer to 12-10-00, Tires and 6-00-00, Chart 1.)................................................... O O
14. Check brake hydraulic lines for leakage, condition, and security .......................... O
15. Inspect hydraulic lines, electrical leads, and attaching parts for
condition and security (i.e. - routing, chafing, damage, wear, etc.) ....................... O
16. Check brake reservoir for proper fluid level, leaks,
condition, and security .......................................................................................... O O
17. Inspect gear fork for damage ................................................................................ O