Piper Aircraft Corporation Malibu Mirage PA-46-350P, Airplane Maintenance Manual

Page: 377 / 1956

PAGE 11
Feb 28/07 2G3
22-10-00
PIPER AIRCRAFT, INC.
PA-46-350P, MALIBU MIRAGE
MAINTENANCE MANUAL
3. Components
A. Panel-Mounted Components
The flight director, HSI, autopilot programmer/computer, altitude selector/alerter (if installed),
remote annunciator, and turn coordinator are either face-mounted or rack-mounted in the
instrument panel. See 39-10-00 for removal and installation instructions.
B. Component Locator
See Figure 2.
C. Trim Monitor
The trim monitor is mounted on the underside of the fwd-most access panel in the cockpit floor at
the co-pilot’s feet.
(1) Removal
(a) Remove carpet to expose access panel.
(b) Remove screws holding access panel to floor and open access panel to expose trim
monitor and autopilot harness.
(c) Disconnect autopilot harness.
(d) Remove screws (4) holding trim monitor to access panel and remove trim monitor.
(2) Installation
(a) Place trim monitor in position on underside of access panel and and secure with screws (4).
(b) Connect autopilot harness.
(c) Place access panel in position and secure with screws.
(d) Replace carpet over access panel.
(e) Check system operation - perform Manual Electric Trim Test under Post-Maintenance
Operational Checkout, above.