Piper Aircraft Corporation Malibu Mirage PA-46-350P, Airplane Maintenance Manual

Page: 1490 / 1956

PAGE 20
Feb 28/07
7I20
77-40-00
PIPER AIRCRAFT, INC.
PA-46-350P, MALIBU MIRAGE
MAINTENANCE MANUAL
(e) Upon entry into the exceedance review mode, two possible presentations will be
displayed based on the status of the QDI/EDI's exceedance memory.
1 No Exceedance Data Found In Memory
In the event no exceedance data is found, an "E Clr" prompt will be displayed. (See
Figure 9, View A). At this point, the operator can exit the exceedance review mode.
2 Exceedance Data Found In Memory
When exceedance data is found in memory, the QDI/EDI will display the peak
exceedance data for the first indicator found in memory.
(e) Peak Exceedance Display
1 The peak exceedance display format for an analog indicator is illustrated in Figure
10. An analog indicator with an exceedance displayed is identified by both the red or
yellow and green LEDs flashing. The operation of the analog indicator is not affected
during exceedance review.
2 The peak value of the exceedance will be displayed digitally above the analog
indicator under review.
3 The opposite display window will contain an "E" and two numbers. The top number
represents the exceedance event being reviewed for that indicator. The lower number
represents the number of exceedance events that are in memory for that indicator.
(f) Exceedance Average and Time Display
One side of the display will post the average exceedance value in memory, above the
prompt "-A-". The other side of the display will post the exceedance time in seconds above
the prompt "SEC". (See Figure 11.)
Effectivity Peek Exceedance Display
4636132 thru 4636374 Figure 10