Piper Aircraft Corporation Malibu Mirage PA-46-350P, Airplane Maintenance Manual

Page: 1164 / 1956

PAGE 10
Feb 28/07
6G4
51-70-00
PIPER AIRCRAFT, INC.
PA-46-350P, MALIBU MIRAGE
MAINTENANCE MANUAL
Repair of Impacted Damage
Figure 8
3. Pressure Sensitive Safety Walk Installation
Each of the steps on the lower cabin door have an 11.75 in. x 7.50 in. piece of pressure sensitive safety
walk installed on them.
A. Surface Preparation
(1) Allow newly painted surfaces to dry a minimum of 2 hours prior to applying the safety walk.
(2) If the paint becomes contaminated, remove the contamination with clean dry rags or paper
wipers moistened with MIL-S-18718 Safety Solvent.
(3) Prior to applying the safety walk, wipe the applicable surface with a clean dry cloth, ensuring
that no moisture remains on the surface.
B. Application Procedure
(1) Do not apply when surface temperature is below 50°.
(2) Peel back the full width of the protective liner leading edge approximately two inches.
(3) Adhere this edge of the safety walk to the inboard edge of the step.
(4) Remove the remaining protective lines as the safety walk is being adhered to the step.
(5) Roll firmly with a long handled cylindrical brush in both lengthwise directions.