Pioneer XW-HTD630A, Operating Instructions Manual

Page: 11 / 32

Controls and Displays 02
11
En
En
g
lish
1 CHANNEL INDICATORS
Light to indicate the selected channel.
2 CHANNEL
The default setting is CH1 . In case of poor
reception due to interference from other
electrical devices, you can improve reception
by selecting another channel. Each time you
press the button, the channel changes
sequentially:
Each of the 4 channels is allocated a
frequency as follows:
• CHANNEL 1 - 2.414GHz
•
CHANNEL 2
- 2.432GHz
•
CHANNEL 3
- 2.450GHz
•
CHANNEL 4
- 2.468GHz
• Poor reception may cause the audio to be
interrupted or stopped. This is not
malfunction. Try changing the location or
orientation of the transmitter and/or the
wireless speaker to improve reception.
3 Antenna
Transmits signals to the wireless speaker.
4 POWER
Press to switch the unit on or off.
5 TUNED
Lights when the signal from the transmitter is
properly received.
6 WIRELESS MODE
Slide to either select SURROUND or STEREO
mode.
SURROUND
- Sounds going to the surround
left and right channels are heard through the
wireless speakers.
STEREO
- The wireless speaker can be used
as a second stereo speaker system (which will
output the same stereo signal as the main
system) when you use this setting with the
EX
POWER
Advanced Surround mode on the
receiver. You will be able to adjust the sound
of this speaker independently using the
VOLUME control (see below).
• Before switching to either mode, stop the
DVD player.
• If the AV receiver and wireless speaker
modes do not match, the wireless
speaker system may produce loud sound.
• When set to SURROUND , the VOLUME
control does not function.
7 CHANNEL button
The default setting is
AUTO
. Press and hold
for more than 5 seconds to switch between
AUTO
and
MANUAL
.
The reception channel is temporarily locked
when set to
MANUAL . Switching to
MANUAL may improve reception in some
cases. The
CHANNEL
changes as follows
each time you press the CHANNEL (AUTO/
MANUAL) button:
Press CHANNEL (AUTO/MANUAL)
repeatedly until the same channel as the
transmitter is selected.
When the
POWER
is turned off, the
CHANNEL setting reverts to AUTO . Normally,
use the
AUTO
setting.
• When AUTO is selected, the same
channel as the transmitter is selected
automatically.
• When MANUAL is selected, be sure to
select the same channel as the
CH 2 CH 3 CH 4 CH 1
CH 2 CH 3 CH 4 CH 1
En_XW-HTD630.book 11 ページ ２００３年１２月２６日 金曜日 午後１時９分