Pioneer X-SMC1-K, Operating Instructions Manual

Page: 28 / 120

Changing the settings 10
28
En
Sound settings
Using sound retriever
1 Press SOUND to select Sound Retriever.
2 Use
/
to select or .
The newly set value dis p lays fo r 5 seconds, and then the
setting is com p leted.
– The selected sound effect is activated.
–The selected sound effect is deactivated.
About Sound Retriever
This function enhances sound data lost du r ing com pr ession
of MP3 and othe r file ty p es, allowing the use r to enjoy sound
quality close r to that of the o r iginal signal data.
Using virtual surround
1 Press SOUND to select Virtual Surround.
2 Use
/
to select or .
The newly set value dis p lays fo r 5 seconds, and then the
setting is com p leted.
– The selected sound effect is activated.
–The selected sound effect is deactivated.
Adjusting the bass and treble
Use the bass and t r eble cont r ols to adjust the ove r all tone.
1 Press SOUND to select Bass or Treble.
2 Use
/
to adjust the bass or treble.
You can adjust low and high sounds on a scale of
–5
to
+5
(eleven ste p s).
– Bass +5
– Bass -5
– T
r eble +5
– T r eble -5
The newly set value dis p lays fo r 5 seconds, and then the
setting is com p leted.
Restoring all the settings to the defaults
Note
• Use the ste p s below to r esto r e the above settings to thei r
defaults.
1 Press

STANDBY/ON to turn the power on.
2 Press and hold

and

STANDBY/ON no
the top panel for three seconds.
‘ ’ is dis p layed while the settings a r e being
r esto r ed.
X-SMC1_CUXZTSM_En.book 28 ページ ２０１１年７月８日 金曜日 午後１２時５４分