The System Setup menu
05
34
En
Speaker Distance
For good sound depth and separation from
your system, you need to specify the distance
of your speakers from the listening position.
The receiver can then add the proper delay
needed for effective surround sound.
1
Select ‘SP DISTN.’ from the SP SETUP
menu.
2
Use
/
to choose the speaker that you
want then set the distance.
Use
/
to adjust the distance of each
speaker (in 0.1 m increments).
The Input Assign menu
You only need to make settings in the Input
Assign menu if you didn’t hook up your
equipment according to the default settings for
the component video inputs.
• Default settings:
COMP 1
–
BD DVD
COMP 2
–
TV
If you didn’t make component video
connections according to the defaults above,
you must assign the numbered input to the
component you’ve connected (or else you may
see the video signal of a different component).
For more on this, see
Connecting your
component with no HDMI terminal
on page 18.
1
Select ‘IN ASSIG’ from the System Setup
menu.
2
Select ‘COMP. IN’ from the ‘IN ASSIG’
menu.
3
Use
/
to select the number of the
component video input to which you’ve
connected your video component.
The numbers match the numbers beside the
inputs on the rear of the receiver.
4
Select the component that corresponds
with the one you connected to that input.
• Use the
/
buttons and
ENTER
to select
BD DVD
,
TV
,
DVR
,
MCI
(
MULTI CH IN
) or
OFF
.
• If you assign a component input to a
certain function, any component inputs
previously assigned to that function will
automatically be switched off.
• Make sure you have connected the audio
from the component to the corresponding
inputs on the rear of the receiver.
• If you connect any source component to
the receiver using a component video
input, you should also have your TV
connected to this receiver’s
COMPONENT
VIDEO OUT
jacks.
• For the assignment of the digital signal
inputs, see
Selecting the audio input signal
on page 25.
VSX-RS320_DWXCN.book 34 ページ ２０１０年４月２日 金曜日 午後５時４６分
