Pioneer VSX-95, Operating Instructions Manual

Page: 95 / 164

95
Using other functions
10
Resetting the system
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to
MULTI ZONE OFF .
!
Disconnect the iPod and USB memory device from the receiver beforehand.
! Set the Control with HDMI to OFF (see HDMI Setup on page 86 ).
1 Switch the receiver into standby.
2 While holding down ENTER on the front panel, press
u
STANDBY/ON.
The display shows
RESET
c
NO
d
.
3 Select ‘RESET’ using PRESET k / l , then press ENTER on the front panel.
The display shows RESET? OK .
4 Press ENTER to confirm.
OK
appears in the display to indicate that the receiver has been reset to the factory default settings.
! Note that all settings will be saved, even if the receiver is unplugged.
Default system settings
Setting Default
SPEAKERS SB/TMd ON <a>/ ON <b>
Speaker System 7.2ch/5.2.2ch <a>/ 5.2ch <b>
Speaker Setting
Front
SMALL
Center
SMALL
TMd
<a>
SMALL
FW
<a>
SMALL
Surr SMALL
SB
<a>
SMALLx2
SW YES
Surround Position
<a>
ON SIDE
Crossover 80Hz
X-Curve OFF
DIMMER Brightest
Inputs
See Input function default and possible settings on page 63 .
Input Volume Absorber All Inputs 0dB
HDMI
HDMI Audio AMP
Control OFF
Control Mode --- (OFF)
ARC (Audio Return Channel) --- (OFF)
Standby Through OFF
4K/60pBD 4:2:0
4K/60pH1 (HDMI IN 1)
4:2:0
Setting Default
4K/60pH2 (HDMI IN 2) 4:2:0
DSP
Power On Level LAST
Volume Limit OFF
Mute Level FULL
Phase Control ON
Auto Sound Retriever OFF
Sound Delay 0 ms
Dual Mono CH1
DRC
OFF
LFE Attenuate
0dB
Auto delay OFF
Digital Safety OFF
Effect Level ALC (Auto Level Control) 50
Center Spread
<a>
OFF
PL II Music Options
<b>
Center Width 3
Dimension 0
Panorama OFF
Neo:6 Options Center Image
Neo:6 CINEMA: 10
Neo:6 MUSIC: 3
All Inputs
Listening Mode (2 ch/multi ch) AUTO SURROUND
Listening Mode (Headphones)
STEREO
See also Setting the Audio options on page 89 for other default DSP settings.
MCACC
MCACC Position Memory M1. MEMORY 1
Channel Level (M1 to M6) 0.0 dB
Speaker Distance (M1 to M6) 10’00’’
Standing Wave (M1 to M6)
ATT of all channels/filters 0.0 dB
SWch Wide Trim 0.0 dB
EQ Data (M1 to M6)
All channels/bands 0.0 dB
EQ Wide Trim 0.0 dB
Network
Network Standby ON
DHCP
ON
a VSX-90 only.
b VSX-45 only.