76
≫
≫
≫
≫
≫
≫
Playing Back
In the remote controller operation, while pressing and holding the ZONE 2 SHIFT
button on the remote controller, operate with each button.
1.
Point the remote controller at the unit, and while pressing and holding the
ZONE 2 SHIFT button on the remote controller, press
.
• "Z2" on the display of the main unit lights up.
2.
While pressing and holding the ZONE 2 SHIFT button on the remote controller,
press the input selector of the input source you want to play in the separate room.
On the main unit, after pressing ZONE 2-CONTROL button, within 8 seconds turn
the input selector dial to select the input to be played in the separate room.
3.
You can adjust the ZONE speaker volume with the volume button while
pressing and holding the ZONE 2 SHIFT button on the remote controller. To
do this on the main unit, press ZONE 2-CONTROL button, and then within
8 seconds, adjust the volume using the MASTER VOLUME dial.
•
If you turn the unit to standby during multi-zone playback, the Z2 indicator is
dimmed, and the playback mode is switched to playback in a separate room
only. Setting ZONE 2 to on while the unit is in standby also switches the
playback mode to playback in a separate room only.
• When audio is being output from the ZONE SPEAKER, surround back
speakers or height speakers cannot play audio. (North American models)
• The audio from externally connected AV components can be output to ZONE 2
only when the audio is analog or 2 ch PCM signal. When the AV component is
connected to this unit with a HDMI cable, digital coaxial cable or digital optical
cable, change the audio output of the AV component to the PCM output.
•
When video and audio via HDMI input are output to ZONE 2, set "Input/Output
Assign" - "TV Out / OSD" - "Zone 2 HDMI"
(
) to "Use" on the System
Setup menu.
•
DSD audio signals cannot be output to ZONE 2 when selected with the "NET"
or "USB" input selector.
•
If ZONE 2 is on, power consumption during standby will increase.
To set the function to off:
While pressing and holding ZONE 2 SHIFT button,
press . Alternatively, press the ZONE 2-ON/OFF button on the main unit.
