73
≫
≫
≫
≫
≫
≫
Setting Item
Default Value
Setting Details
Surround
Small
Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
•
When "Front" is set to "Small", this is set to
"Small".
•
If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Crossover
80Hz
When there are speakers that have been set to
"Small", set the Hz under which you would like
other speakers to play bass, and also set Hz under
which you would like the LFE (low frequency effect)
to play the bass.
The value from "50Hz" to "200Hz" can be set.
Double Bass
On
This can be selected only when "Configuration"
- "Subwoofer" is set to "Yes" and "Front" is set to
"Large".
Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
•
The setting will not automatically be configured
even if you performed Full Auto MCACC.
3. Distance
Set the distance from each speaker to the listening position.
Setting Item
Default Value
Setting Details
Front Left
10.0 ft/3.00 m
Specify the distance between each speaker and
the listening position.
Center
10.0 ft/3.00 m
Specify the distance between each speaker and
the listening position.
Front Right
10.0 ft/3.00 m
Specify the distance between each speaker and
the listening position.
Height Left
10.0 ft/3.00 m
Specify the distance between each speaker and
the listening position.
Height Right
10.0 ft/3.00 m
Specify the distance between each speaker and
the listening position.
Surround Right
10.0 ft/3.00 m
Specify the distance between each speaker and
the listening position.
Surround Left
10.0 ft/3.00 m
Specify the distance between each speaker and
the listening position.
Subwoofer
10.0 ft/3.00 m
Specify the distance between each speaker and
the listening position.
•
Default values vary depending on the regions.
•
The unit of distance can be changed by pressing the MODE button on the remote
controller. When using the unit "feet", the setting is available in increments of 0.1 ft from
0.1 ft to 30.0 ft. When using the unit "meter", the setting is available in increments of
0.03 m from 0.03 m to 9.00 m.
