3
3
16
Basic Setup
Automatically setting up for surround sound
(MCACC)
Place the supplied setup microphone in the listening position,
measure the test tones emitted by the speakers, then the unit
automatically sets the optimum volume level for each
speaker, the crossover frequencies, and the distance from
the listening position. This also enables correction of
distortion caused by the acoustic environment of the room.
CAUTION
•
The test tones used in the Full Auto MCACC setup are
output at high volume.
Important
•
The OSD will not appear if you have connected using the
composite output to your TV. Use HDMI connection for
Full Auto MCACC setup.
•
The Full Auto MCACC setup will overwrite any existing
speaker settings you’ve made.
•
Before using the Full Auto MCACC setup, the
USB
input
should not be selected as an input source.
1
Switch on the receiver and your TV.
2
Switch the TV input to the input that connects this
receiver to the TV through the corresponding HDMI
cable.
3
Connect the microphone to the SETUP MIC jack on the
front panel.
Make sure there are no obstacles between the speakers
and the microphone.
If you have a tripod, use it to place the microphone so
that it’s about ear level at your normal listening position.
Otherwise, place the microphone at ear level using a
table or a chair.
4
Press
BD
button on the remote control to switch to BD/
DVD entry.
5
Press
HOME MENU
button.
The
Home Menu
appears on your TV. Use
/
/
/
and
ENTER
on the remote control to navigate through
the screens and select menu items. Press
RETURN
to
exit the current menu.
•
Press
HOME MENU
at any time to exit the
Home
Menu
. If you cancel the Full Auto MCACC setup at
any time, the receiver automatically exits and no
settings will be made.
•
The screensaver automatically starts after three
minutes of inactivity.
6
Select “Full Auto MCACC” from the Home Menu, then
press
ENTER
.
7
Press
ENTER
again.
•
Mic In!
blinks when the microphone is not connected
to
SETUP MIC
jack.
Try to be as quiet as possible after pressing
ENTER
.
The system outputs a series of test tones to establish the
ambient noise level.
8
Follow the instructions on-screen.
•
Make sure the microphone is connected.
•
Make sure the subwoofer is on and the volume is
turned up.
•
See below for notes regarding background noise and
other possible interference.
RECEIVER
RECEIVER
AUDIO SEL
AUDIO SEL
SAT
SAT
STREAM BOX
STREAM BOX
DVD
DVD
CBL
CBL
BD
BD
S.BOX
S.BOX
USB
USB
AV
AV
ADJUST
ADJUST
MUTE
MUTE
HOME
HOME
MENU
MENU
HOME
MENU
HOME
MENU
RETURN
RETURN
RETURN
RETURN
TOP
TOP
MENU
MENU
VOLUME
VOLUME
AUX INPUT
SETUP MIC
H o m e M e nu
1 . F u l l
Auto MCACC
2.Manual SP Setup
3.Input Assign
4.Auto Power Down
5.HDMI Setup
R e t u r n
VSX-532_CDC_En.book 16 ページ ２０１７年１月１２日 木曜日 午後３時１２分
