Pioneer VREC-DH200, Owner'S Manual

Page: 26 / 34

− 26 −
English
This Product Settings
Before using this product, first stop the vehicle in a safe location and apply the handbrake.
Use the exclusive app to configure product settings.
→
“ Exclusive App”
Features that can be configured are as follows.
You can also confirm different information.
Setting
Category
Setting Details Default Settings
Device
settings
Microphone
You can set whether or not to record sound around
this product during video recording.
OFF
Beep You can set whether or not to sound beeps. * 1
ON
G sensor flexible You can set the event recording sensitivity. Middle
Bitrate You can set the bit rate level
* 2
Middle
Waving
You can set the sensitivity of the gesture sensor.
This can also be set to OFF.
High (8 cm)
Parking sensitive
You can set the sensitivity for detecting vibration
or impact in parking mode. This can also be set
to OFF.
Middle
Delay shutdown You can set the time until this product shuts down
after power supply to the product is stopped.
Shutdown
rightaway
Device info
SSID The SSID name (access point name) and password
of this product can be checked and changed.
After changing the password, if you forget this,
then reset the product to default settings.
—
Password
Version
Allows you to check the version information of this
product firmware.
System
settings
Format SD card All files on the microSD card can be deleted.* 3
—
Restore Settings can be reset to the default settings.
* 1 Even if this is set to OFF, if an error occurs (including microSD card not inserted), then an error
sounds.
* 2 Increasing this level will give better image quality, however video may not play back smoothly when
viewing through the exclusive app. If downloaded to a smartphone, video will play smoothly.
Decreasing this level will mean lower image quality, but video will play back smoothly when viewing
through the exclusive app, without downloading to a smartphone.
* 3 When there is a problem with the microSD card, a warning tone sounds, and the system indicator
blinks red.
Note
• GMT data from a smartphone can be transferred by connecting to the smartphone app.