SX-315
43
5
6
7
8
5
6
7
8
C
D
F
A
B
E
7. GENERAL INFORMATION
7.1 DIAGNOSIS
7.1.1 TROUBLE SHOOTING
The Protection circuit is activated by DC or overcurrent detection.
Detection method:
The voltage at the Protection port (Pin 7) of the microcomputer becomes low.
Time required for detection:
2.5 sec after the power is turned on
Operation when the Protection circuit is activated:
• Mute: ON
• Speaker Relay: OFF
• The unit immediately enters Standby mode.
Recovery method:
Press the STANDBY key twice.
When the DC detection circuit is not normal
When the overcurrent detection circuit is not normal
• BD501 and BD502 are in failure or their peripheral circuits are short-circuited.
• Power amp section is in failure.
• Protection circuit is in failure.
• Microcomputer is in failure. (pin 7: protection)
• Power amp section is in failure.
• Protection circuit is in failure.
• Microcomputer is in failure. (pin 7: protection)
• Only when the signal is output, short-circuiting of the output circuit is suspected.
Summary of Contents for SX-315
