Pioneer Super Tuner IIID AVH-P5200BT, Operation Manual

Page: 62 / 96

System settings
Switching the auxiliary setting
Activate this setting when using an auxiliary
device connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 54.
2 Touch AUX Input on the system menu
to turn AUX Input on or off.
Setting AV input
Activate this setting when using an external
video component connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 54.
2 Touch AV Input on the system menu to
turn AV Input on or off.
Setting the rear output and
subwoofer controller
This unit
’
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Full
) or subwoofer
( Subwoofer ) connection. If you switch the
rear output setting to Subwoofer , you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for a rear full-range
speaker connection (
Full ).
1 Turn the unit off.
Refer to Basic Operations on page 11.
2 Display the system menu.
Refer to Introduction of menu operations on
page 54.
3 Touch Rear Speaker on the system
menu to switch the subwoofer output or
full-range speaker.
#
When no subwoofer is connected to the rear
output, select Full (full-range speaker).
#
When a subwoofer is connected to the rear
output, select Subwoofer (subwoofer).
#
When the rear output setting is Subwoofer ,
you cannot operate the following procedure.
Notes
!
Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to
Using subwoofer output on page
56).
!
If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
!
Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Switching sound muting/
attenuation
Sound from this system is automatically
muted or attenuated when a signal from
equipment with a mute function is received.
!
Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Display the system menu.
Refer to Introduction of menu operations on
page 54.
2 Touch Mute/ATT until the desired set-
ting appears.
Touch Mute/ATT until the desired setting ap-
pears in the display.
!
Mute
–
Muting
!
ATT -20dB
–
Attenuation ( ATT -20dB has a
stronger effect than
ATT -10dB
)
!
ATT -10dB
–
Attenuation
!
Off
–
Turns the sound muting/attenuation
off
En
62
Section
14
Menu operations