31
> Settings
|
MCACC Pro
Setup the speakers automatically or make advanced settings. You can also check the
values set currently for each speaker setting.
Operation
:
Use the on-screen displays (OSD) that appear on the TV to make the settings.
Press on the remote controller to display the Home screen, then select MCACC Pro with
the cursors on the remote controller and press ENTER.
Select the item with the cursor / / / buttons of the remote controller and press
ENTER to confirm your selection.
Use the cursors / to change the default values.
•
To return to the previous screen, press .
•
To exit the settings, press .
Full Auto MCACC
Place the supplied speaker setup microphone in the listening position, measure the test
tones emitted by the speakers, then the unit automatically sets the optimum volume level
for each speaker, the crossover frequencies, and the distance from the listening position.
The influence of standing waves can be reduced to suit the listening environment, the
reverberation characteristics can be measured to increase the precision of calibration,
the speaker equalizers can be adjusted, and the difference in phase and timing between
speakers and speaker units can be corrected. These settings and calibrations can be
readjusted with Manual MCACC, and you can enable or disable them in AV Adjust.
•
Calibration takes between 3 to 12 minutes to be completed. The speakers emit the test
tone at high volume during measurement, so be careful of your surroundings. Keep the
room as quiet as possible during measurement.
•
If the power of this unit suddenly turns off, the wires in the speaker cables may have
touch the rear panel or other wires and tripped the protection circuit. Twist the wires
again properly and make sure they do not stick out of the speaker terminals when
connecting.
1. Place the supplied speaker setup microphone in the listening position, and connect to
the MCACC SETUP MIC jack on the main unit.
MCACC
SETUP MIC
When putting the speaker setup microphone on a tripod, refer to the illustration when
putting it in place.
•
To cancel Full Auto MCACC partway through, disconnect the speaker setup
microphone.
2. Select the connected speaker configuration, and select the calibration type for which you
want to save the measurement results from amongst "Symmetry", "All Channel Adjust",
and "Front Align".
Summary of Contents for SC-LX901
Page 35: ...35 ...
