32
Multi-zone
> Install
> Playback
Troubleshooting | Supplementary Information, etc.
Basic Operations
You can enjoy audio in the separate room
by, for example, playing a Blu-ray Disc
player in the main room (where this unit is
located) and listening to internet radio in
the separate room (ZONE 2).
0
DSD and Dolby TrueHD audio signals
are not output to ZONE 2 when selected
with the "NET" or "USB" input selector.
0
You can only select the same inputs for
the main room and separate room with
the "NET", "BLUETOOTH", or "USB"
input selector. If you have "NET"
selected in the main room and then
select "BLUETOOTH" in the separate
room, the main room also switches to
"BLUETOOTH". You cannot select
different stations for the main room and
separate room with the AM/FM radio.
0
Power consumption in standby mode
increases when the multi-zone function
is being used.
Perform the following procedure when the
unit is on.
1. While holding down MODE (e) on the
remote controller, press ZONE 2 (d) for 3
or more seconds until the remote
indicator blinks twice.
0
The remote controller switches to the
mode for controlling ZONE 2.
2. Point the remote controller at the main
unit and press
Í
(a).
"Z2" lights on the main unit display.
3. Press the input selector button (b) of the
input to be played in the separate room.
0
On the main unit, after pressing ZONE
CONTROL, within 8 seconds turn the
INPUT SELECTOR dial to select the
input to be played in the separate
room.
4. To adjust the volume on the power
amplifier in the separate room or the
ZONE speaker, adjust with VOL+/– on
the remote controller. To control on the
main unit, press ZONE CONTROL and
adjust with the MASTER VOLUME dial
within 8 seconds.
0
Adjust the volume on the pre-main
amplifier if you have connected with a
pre-main amplifier in the other room.
0
The information for a connected
device can be displayed on the TV
screen in a separate room. Press the
button while the remote controller
is in the mode for controlling ZONE 2.
To turn off the function:
Press
Í
while in the mode for controlling
ZONE 2 on the remote controller.
Playing in ZONE 2 only:
If you turn the unit to standby during multi-
zone playback, the Z2 indicator is dimmed
and the playback mode is switched to
playback in a separate room only. Setting
ZONE 2 to on while this unit is in standby
will also switch the playback mode to the
same setting.
1
2
3
c
d
e
a
b