15
En
Step2: Connect the Speakers
Standard Connections (Pages 8 to 12)
Connect
12345678
for a 7.1 channel system.
Connect
1234569:
for a 5.1.2 channel system. Up
to two powered subwoofers can be connected. The same
signal is output from each of the SUBWOOFER PRE OUT
jacks.
0
You can also connect both
78
and
9:
. However, you
can only output audio from one of these at a time. When
both are connected, you can switch which speakers to
prioritize. Press
on the remote control (P6) and use
"Other" - "Speakers" to switch between surround back
speakers and height speakers and to switch speakers A
and B.
Make sure the exposed speaker cables do not
stick out of the speaker terminals when
connecting. If the exposed wires of the
speakers touch the rear panel or the + and –
wires touch each other, the protection circuit
will be activated.
> Install
> Playback
Troubleshooting | Supplementary Information, etc.
a
b
3/8˝
(10 mm)
OR
Speaker B
a
Speaker Cable,
b
Subwoofer Cable
Setup
0
Settings for the speaker configuration you have
connected need to be made in "1. Full Auto
MCACC" in Initial Setup (P26).
